Subscribe Contribute Advertise Facebook Twitter Instagram Forums Newsletter

Reader Reviews

Add your own review

Zelph's Stoveworks SS Starlyte Ultralyte Alcohol Stove

in Stoves - Alcohol

Average Rating
5.00 / 5 (5 reviews)

Display Avatars Sort By:
Tony Beasley
( tbeasley )

Pigeon House Mt from the Castle
Zelph's Stoveworks SS Starlyte Ultralyte Alcohol Stove on 05/09/2009 00:36:15 MDT Report Post Print

Rating: 5 / 5

Technical review of Zelph's Stoveworks SS Starlyte Ultralyte Alcohol Stove and E-Z fold windscreen.

Stove type

The stove is a wickerized open top alcohol stove with a built in pot stand.

First impressions

I am a machinist and a have a strong interest in designing and making BP stoves and I am very critical of the manufacturing quality of other MYOG stoves. When I unpacked the Starlyte stove I noticed that it is well made and presented, the stove came with a well made E-Z fold windscreen, the quality of the Starlyte actually impressed me.

Construction and materials

The stove is made from a small aluminum tin with the top cutout and filled with fiberglass with a stainless steel cover to hold the fiberglass in, four holes have been drilled equal spaced around the edge where the integrated pot stand was then place, the pot stand is made from two pieces of stainless steel wire which have been spot welded together and then bent to fit into the holes. The windscreen is made of aluminum which has been crinkled, the clip that came with the screen is a hanger from a curtain.


Weights as measured on my scales
Stove: 14.8 grams (this is as advertised)
The E-Z fold windscreen: 21.2 grams
Clip that came with the windscreen to hold it together: 3.4 grams
Measuring cup: 3.4 grams
Total of 42.8 grams

Diameter of stove: 55 mm
Height of stove and pot stand: 44 mm


Test condition was in my garage at 600 meters elevation, the ambient temperature was around 170C, I used Australian denatured alcohol 95% ethanol content. In each test I place 20 grams of fuel in the stove and after reaching 950C as quickly as possible I placed a tin over the stove to put the flame out, this was the same for all tests.

I ran four tests on the starlyte stove (heating rates can be seen in graph below) in each test I heated 0.5 liters of water from tap temperature to 950C and then normalized the results to grams used to heat water 800C (g/800C). As the stove was sitting directly on my test bench and the test surface was warming up between tests I placed a cooled piece of 3 mm ply under the stove before each new test.


1/ 14.0 g/800C
2/ 16.0 g/800C
3/ 13.1 g/800C
4/ 12.3 g/800C

Average of test 1,3 &4 = 13.1 grams or about 16.4 mls

Note test 2: while doing the test I noticed that the pot was not central on the stove, I must have knocked the stove off center while placing the pot on it, I decided to leave this incorrect placement until the end of the test, this non central placement showed more fuel being used than the other tests.

Notes test 1&3: in these tests the windshield was left slightly open so I could look at the flame, I suspect this might have some effect on the efficiency.

Notes test 4: in this test I had the windshield full closed, as can be seen in the results this was the most efficient test.

Discussion of results

When used correctly the Starlyte stove used similar amount of fuel to my Trangia 27-1 which I consider a standard amongst alcohol stove this is very impressive as the Starlyte system is much lighter than the Trangia

Testing the no spilling claim.

I filled the stove with 20 grams of alcohol, lit the stove and then tipped the stove over on my testing bench to try and see what would happen, surprisingly as can be seen in the photo no fuel spilled out of the stove, the flame just stayed coming out of the stove.

Tipped over stove
Trying to spill fuel from the Starlyte stove (CAUTION DO NOT TRY THIS WITH OTHER ALCOHOL STOVES)


I found the Starlyte very easy to use, I had no problems with the filling of fuel, the fiberglass wick filling had no problems absorbing the fuel. The stove ignited very easy, it only took a touch of the lighter that I was using.

The windscreen was easy to unroll and rollup and to setup around the pot, the clip that was supplied was also easy to put on and the clip was useful in removing the windscreen after the water had reached the desired test temperature.

The stove pot is supported by 4 legs these where not perfectly leveled and the pot had a very small amount of rocking but with a little bit of adjustment this can be easily fixed.

I have not used this stove in the field as yet and if I like to cook gourmet meals and for this reason I prefer Canister stoves, but I have ran a lot of tests on many different alcohol stoves and I really enjoyed using this stove.


Starlyte stove with windsreen
SS Starlyte Ultralyte Alcohol Stove

Starlyte flame under pot
Starlyte flame under pot

Shop E-Z, Trangia products at GearBuyer
Steve Martell
( Steve )

Eastern Washington
Zelph's SS Starlyte Alcohol Stove on 07/04/2009 21:40:46 MDT Report Post Print

Rating: 5 / 5

Very nice stove—may even replace my trusty “Pepsi-can” stove.

Pros: Light weight with integrated pot support. Very quiet and very fuel efficient. Looks neat.

Cons: Pot support not perfect. I would have preferred a small weight penalty and have the wire supports form an outside square pattern vs. the “X” pattern

Test Data: Boiled 2 cups of 50F water in 9 minutes on 22 ml of alcohol. Fuel burnout at 13 minutes.

Tip #1: Improve cold weather use by keeping fuel warm (above it's 57F flash point). Store it in a mini bottle (2oz flat oval) in a shirt pocket. Extra (bulk) fuel is kept in the pack.

Tip#2 Minimize fuel used my measuring it—use plastic test tube that holds 22ml. Pour only this amount into the stove. Add a little more when windy or if water is extremely cold and less when it's not.

Tip#3 Improve efficiency by adding a reflector (foil) below the stove.

Barnett Childress
( Barnett_Childress )

New England
Excellent Performer on 08/07/2009 07:38:10 MDT Report Post Print

Rating: 5 / 5

I am very impressed by this stove! It has become my new 3 season stove. Excellent construction, very light weight, .52oz with built in pot stand.

I really like the thought that went into this stove. Simple top burner, built in SS wire pot support eliminates having to carry an extra stand like a cloth wire stand. Fiberglass fill & SS mesh screen keep the fuel in the stove. Very easy to light before or after the pot is on the stove. The 2" dia and 1.75" height of the stove is perfect for small dia pots & beer kegs. Top burner with no jets keeps the flame under the pot! Ive had great results with the Firelite 550 & Beer keg pots. Throw in a trimmed to size Ti foil WS and you have a super SUL solo cook kit.

I've been able to consistently get 1.5 cups of 65F water to boil in approx 5 min with an additional 2min of burn on 20ml of fuel.


Edited by Barnett_Childress on 08/07/2009 07:39:04 MDT.

Christopher Holly
( climber72 )

At my desk
As advetised this thing is really pretty neat! on 07/01/2010 20:50:56 MDT Report Post Print

Rating: 5 / 5

So I have not yet used this stove on the trail, but have done a couple 'back stoop' tests with it. Pasadena is about 850 feet above sea level and the boil times I observed are well within the above stated parameters.

What I like most about this stove so far is the compact, lightweight design and the ability to use most of the commonly available pots - be it an Evernew, MSR or REI TI pot, beer can or probably even a Sierra Cup (not tested), this stove seems as stable as the Pocket Rocket but at a fraction of the weight. Great!

Over the past 4 years I have used, almost exclusively, a Jetboil PCS for camping, climbing and backpacking needs. I love it. But with a JMT Thru Hike coming up a year from now I started to really think about my pack weight. The Starlyte was highly reviewed and I decided to pull the trigger early so I might experiment on training hikes. I will no doubt post the results of these here later, but for now I am exceedingly happy with my first UL stove purchase!

Great stuff!

Shop Jetboil, MSR, Rei, Rocket products at GearBuyer
Christopher Holly
( climber72 )

At my desk
As advetised this thing is really pretty neat! on 07/01/2010 21:21:48 MDT Report Post Print

Rating: 5 / 5

edit - double post due to spotty connection. Sorry!

Edited by climber72 on 07/08/2010 19:16:36 MDT.

Add your own review