Jason, James, et al,
Thanks, yes the stove is the same design as the white box, except downsized.Since I usually buy large quantities of bottles any way I bought a couple dozen of the smallest aluminum bottles available (I think they are 2.7 ounce bottles). First you need to determine the height of the stove (mine is 1 1/4"), mark that height from the bottom and cut it off (I use a band saw, but a dremel will work just fine). Then measure down from the opening in the bottom piece you just cut 1/4" and thats the height of the jet holes. I used a 3/64 bit and spaced the holes about 1/8" apart. You want to drill the jets before assembly because the otherwise you'll drill throug the inner chamber after assembly.Then you take the piece thats left, and on the neck end cut a couple of short (1/16-1/18")notches in the end of the neck to act as weep holes. At that point you place the neck of the bottle into the bottom you cut off and press them together until it bottoms out. Because it's such a small bottle it doesn't need to be riveted.I'll see if I can get pics together in the next couple of days.
Also, if any body would like one but doesn't want to be bothered I have them available for $9.00 including primer pan and windscreen,or $9.75 also including a 1 ounce fuel bottle, plus $3.00 for shipping USA (I will quote shipping outside US. Just PM me or contact me at email@example.com