Subscribe Contribute Advertise Facebook Twitter Instagram Forums Newsletter
SP 600 Cozy from GG Thinlight 1/8 trimming
Display Avatars Sort By:
Bradley Jay
(standupdouble) - F
SP 600 Cozy from GG Thinlight 1/8 trimming on 05/21/2012 08:12:07 MDT Print View

So I have a really basic question but seem to be having a hard time finding an answer: So I've traced and cut everything out to make a cozy for my sp600 however I can't decide what is the best way to attach the bottom piece and the two ends that wrap around my mug. Is there an adhesive that will bond closed cell foam without disfiguring it? I've seen people use tyvek tape for cozys made of reflective bubble wrap - is this also the way to go with closed cell foam?

Any suggestions would be much appreciated.

Nancy Twilley
(goodcaver2)

Locale: STL
tape on 05/21/2012 09:59:50 MDT Print View

duct tape will definitely work!

todd harper
(funnymoney) - MLife

Locale: Sunshine State
Re: SP 600 Cozy from GG Thinlight 1/8 trimming on 05/21/2012 10:03:08 MDT Print View

Silicone adhesive (& probably caulk) will work. Done it!

Bradley Jay
(standupdouble) - F
Thanks on 05/21/2012 10:05:30 MDT Print View

thanks for the responses. I caved and just went with duct tape.

Tommy Franzen
(Tomlike) - F

Locale: Pacific Wonderland
Barge cement on 05/21/2012 10:48:50 MDT Print View

Tape will work, but I recently made basically the same thing and used Barge Cement. You can get it at any hardware store, and it really is like cement once it dries.

Steve B
(geokite) - F

Locale: Southern California
SP 600 Cozy from GG Thinlight 1/8 trimming on 05/22/2012 12:50:45 MDT Print View

I use 5min epoxy, just hold in place until it has set.

Steve