I am contemplating the purchase of an Iso-Clean Stove from Flat Cat Gear.



I would like to make a pot stand out of stainless steel welded wire mesh that would simply be rolled up inside of the stove approximating its internal diameter and rising up the required 3/10ths of an inch above the stoves upper edge.



My description differs from the above image because I intend to roll the wire and insert it into the stove itself and let it press outwardly against the interior wall of the stove.

Does anyone know of a source for a small bit of suitable welded stainless mesh with 1/2" squares?

I'm thinking the wire should be around .020" to 030".

I'd like to keep the pot to stove air gap as unrestricted as possible.

Party On,

Newton

Here you go:

http://www.mcmaster.com/#wire-cloth/=h60jz0

Use Type 304 Stainless Steel Welded Wire Cloth

Dan

Edited by DBthal on 04/18/2012 20:36:15 MDT.

Try this:

http://www.mcmaster.com/#stainless-steel-mesh/=h60k15

Other options there, too (including woven).

Edit: Simultaneous post with Daniel above.

Edited by DavidDrake on 04/18/2012 20:40:57 MDT.

Dan and David,

Thanks for the info. I was actually looking at their site when your responses popped up.

I kept looking for 1/2" x 1/2" welded wire mesh and realized what I didn't know about the sizing.

2 x 2 welded wire mesh is actually 1/2" x 1/2" because the sizing standard is the number of squares in an inch.

Learning all the time I am! L O L

Party On,

Newton

Send me approx. size you need, I will send to you, no charge.

Stephen,

Thank you very much!

Watch for my PM.

Party On,

Newton