I have a piece of .35 cuben that is 100" long, and tapers from 20" down to 14", approximately.

If you can use this for something, let me know.

The first BPL Member who PM's an address gets it.

Edited by greg23 on 04/23/2010 22:11:40 MDT.

pm sent

Konrad... we shall see. I might have beat you... haha

honestly, I am looking to make a small stuff sack or two... maybe we can share?

Mike, if it comes down to between us 2, im totally down to share. Im looking to make some small stuff sacks and maybe use some cuben for one side of a pillow project. Greg could either cut it in 2 and mail (im sure were both down to cover shipping costs) or one of us can cut it and mail it etc.

I can take the smaller end if you have a project that requires the 20 inch side

Edited by Konrad1013 on 04/23/2010 21:28:12 MDT.

I just think its amusing that these PM's get sent within seconds of each other. I guess its just good luck refreshing my "recent threads" page.

Okay sounds good, im sure one of us will hear back from Greg soon...or some secret BPL lurker beat us to the punch...i hate those guys! (I think i lurked for 1 year before making my first post)

Edited by Konrad1013 on 04/23/2010 21:30:57 MDT.

Mike got it.
Konrad - your 1st PM came in same minute, but seconds later.

Mike, it's your call. Do you want it all or just part?

Edited by greg23 on 04/23/2010 21:32:28 MDT.

Thanks for the update Greg. If Mike's still down for splitting it, can I throw you some amount to at least cover postage, time, effort to mail etc? Let me know in a PM.

It's going to cost about 50 cents x 2 to get it done. I can handle that. Pass it along when you get a chance.

Greg,

I will take it. I appreciate you sending it. Thanks!

Konrad, I will cut out some stuff sack patterns and make sure I have plenty left over and forward it to you. Do you know approximate dimensions for your pillow and/or stuff sack project?

Sending you a PM, thanks!

Deal Done.
Mike, I try to get it into tomorrow's mail.

Thanks.

Edited by greg23 on 04/23/2010 22:11:03 MDT.