BPL Community Profile

Adam Kilpatrick (oysters) - BPL Lifetime Member

My Locale South Australia
About Me Into Bushwalking in remote areas in Australia. Have completed alot of walks in Southern Australia, especially in the Flinders Ranges, but also some decent trips in Victoria, Tasmania, and Central Australia.

I also spend a lot of time in the field for work (arid areas) and am an avid Scouter!

Oh yeah, and I'm into cycling and photography too.
CityAdelaide
StateSouth Australia
CountryAustralia
My Website URLhttp://worldtrike.crazyguyonabike.com

You cannot send this user a personal message (PM) because they have not specified a PM email address yet.

All Forum Posts by Adam Kilpatrick

Showing 31 - 40 of 693 | Page: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 ...70
 

Post

Forum » Thread

Re: Sea to Summit Ultra-Sil Nano Poncho (note, new 15D fabric)
Are you sure about the Sil? I'm pretty confident that the S2S fabric does have a light Sil coating on the outer, with the PU on the inside. This is the same as the Golite fabric As the Sil i...

In GEAR » Sea to Summit Ultra-Sil Nano Poncho (note, new 15D fabric)
September 28, 8:29pm

Re: Re: Re: Re: Sea to Summit Ultra-Sil Nano Poncho (note, new 15D fabric)
Hi Sam yeah I've looked a lot at the Golite poncho too (and yeah they sure struggle with supply with just about all their products...). I think I mention it further up in this thread, but I ...

In GEAR » Sea to Summit Ultra-Sil Nano Poncho (note, new 15D fabric)
September 28, 5:17am

Re: Re: Sea to Summit Ultra-Sil Nano Poncho (note, new 15D fabric)
Sam, I thought I found an online sources to basically this material a few weeks ago, but now for the life of me I can't find it! 15D, Sil one side, PU the other, 1200mm. In any case I now...

In GEAR » Sea to Summit Ultra-Sil Nano Poncho (note, new 15D fabric)
September 27, 4:28am

Sensational work this thread. Great thinking OP, KUDOS TO ZPACKS!
Very inspiring stuff. Great to see some excellent collaboration happening :-)

In GEAR » The Frankenstein MLD Exodus/Arc Blast with custom features .....perfect pack?
September 22, 5:42pm

Increasing frame strength
Hi AndE One thing I've always wondered with the Arc Blast frame is how hard it would be to increase its strength for heavier loads (along with a more substantial hipbelt of course) and also ...

In Make Your Own Gear » X-Pac Backpack Pack v2.0 - Z-Packs Arc Blast frame conversion
September 22, 5:38pm

.18 Mylar
I now have a metric metre of .75 cuben, the lighter spectra but .18 mylar variety. My plan is to use it for the outer bottom section of the footbox of a MYOG cuben quilt. I picked the .18 mylar ver...

In GEAR » Cuben Ground = Sieve
September 19, 10:49pm

Re: Backpack Options for Injured Shoulder: Lumbar Packs or Luxurylite Pack???
My first thoughts were the lumbar packs that zimmer does, but with one strap. With a good enough hipbelt (get him to beef it up) it should be able to take an ultralight load with little support fro...

In GEAR » Backpack Options for Injured Shoulder: Lumbar Packs or Luxurylite Pack???
September 15, 11:14pm

Re: Re: argon sil dead?
I just received my four yards of brown argon sil in the mail (in Aus Via a warehouse address-it had to wait for other things before it shipped). Definitely lighter stuff than that of say my trailst...

In Make Your Own Gear » Argon Silnylon Pyramid Tarp - Hex
September 13, 8:26am

Re: pack
Rough calcs for you: Assumptions: 1.4oz cuben currently used. You want 3.4oz dyneema grid 140d? Area of top collar: ~ 10*10*2+10*6*2 = 320in^2 =.25 sq yds Area of sides: ~6*20*2 = .19 sq ...

In Editor's Roundtable » The Best Backpack in the Whole Wide World
September 10, 6:07pm

Re: Phd
Yeah I can't remember them actually posting their fill weights in the past. The best comparison with these will be when someone gets their hands on them and measures loft height.

In GEAR » PHD K Series: 1000 Down, new lighter fabric
September 09, 8:35pm

All Reader Reviews by Adam Kilpatrick

Adam Kilpatrick has posted no reviews.